User manual

User Manual for Matrix Maker
Page 30
“ETX” (End of Text) is similar to STX with the character(s) being sent at the end of the data
stream regardless of the user defined output sequence.
The “Error Symbol” is a character(s) that replaces any character printed on the check that
can’t be read for whatever reason (e.g. damaged check).
The “Space Symbol” is a character(s) that replaces any spaces between the magnetic ink
characters.
9. Operation
Place the check to be read into the right-hand side of the MICR reader slot so that the
magnetic ink is facing away from the keys on the keyboard and so that the ink is at the
bottom of the slot.
Manually slide the check to the left until the motor “grabs” the check and pulls it through the
reader. Depending on the user defined configuration of the MICR reader, it may beep,
return the check to the entry point or leave it at the exit point.
All of the data printed on the check as well as the characters defined to replace the symbols,
STX, ETX, headers and suffixes will be sent to the PC as keyboard data.
10. FCC Statement
FCC Compliance Statement (Part 15.19)
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause
undesired operation.
Warning (Part 15.21):
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.