User manual

User Manual for Matrix Maker
Page 28
Send data if error
If disabled, no data will be sent to the PC if errors were detected when reading the check.
If enabled, data will still be sent to the PC with any missing characters typically being
replaced with the character(s) defined in the “Error Symbol” part of the “Control Character
Mapping” section described in paragraph 8 below.
Always return check to entry
If selected, causes the check to be physically returned to the entry point regardless of any
errors in reading the check.
Never return check to entry
If selected, causes the check to remain at the exit point regardless of any errors in reading
the check.
Return check to entry if good read only
If selected, a check read with errors will remain at the exit point, a check read without errors
will be returned to the entry point.
Return check to entry if bad read only
If selected, a check read without errors will remain at the exit point, a check read with errors
will be returned to the entry point.
Hold at entry
If enabled, the check will be “held” or “gripped” by the reader at the entry point after a read,
thus preventing it from falling out of the plastic guide slot of the plastic enclosure. Else the
check will be “loose” in the guide slot.
Hold at exit
If enabled, check will be “held” or “gripped” by the reader at the exit point after a read, thus
preventing it from falling out of the plastic guide slot of the plastic enclosure. Else the
check will be “loose” in the guide slot.