User manual

User Manual for Matrix Maker
Page 18
5. Firmware Update (excluding USB devices)
On the menu bar, click Keyboard > Update Firmware (or click the icon on the
toolbar). Navigate to the file and click ‘OK’. This will begin the firmware update.
Note that not all products support a firmware update.
6. Diagnostic Menu
This section explains the options available on the Diagnostic menu.
1. Enter Test Mode
Pressing a key will show that key’s position (for testing the keyboard only).
If your keyboard has the key lock feature and the repeat feature is turned
on, the keyboard will continuously send the key lock position. To stop this,
you can press any other key.
2. Exit Test Mode
Pressing a key will show the code programmed to that key.
3. Load Factory Setting
Reload the default factory setting to the device. [NOTE: If you are
programming a USB keyboard, please disconnect and re-plug the keyboard
and close the software after executing this function successfully.]
4. Reset
Reset the keyboard only. (for testing the keyboard only.)
5. Ignore the middle device (For PS/2 device)
If two of our PS/2 devices are connected by loop-through, you can directly
program the device which is connected to the PS/2 port of your PC. If you
want to program the 2
nd
device, you need to ignore the middle device (i.e.
the one which is connected to the PS/2 port of your PC) first. [NOTE: Once
this setting is activated, the middle device will be disabled.]
6. Restore the middle device (For PS/2 device)
Restores function to the middle device if is has been previously disabled.
7. Firmware Version
Displays the current version of the firmware.
8. MCU Type (Disabled)
Gets the type of the MCU being used by the device.