User manual

User Manual for Matrix Maker
Page 12
iii. Customize Code (For PS/2 keyboard only)
This method allows a user to directly assign PS/2 Set 2 Scan Codes for the key.
The codes entered in the “Make Code” field will be sent if the key is pressed
down while the codes entered in the “Break Code” filed will be sent when the
key is released into an up state. For example, the codes in the above diagram
are the Scan Codes for left shift’s make code(12), h’s make code(33), h’s break
code(f0 33), left shift’s break code(f0 12), e’s make code(24), e’s break
code(f0 24), l’s make code(4b), l’s break code(f0 4b), o’s make code(44) and
o’s break code(f0 44).
Note:
1. Please enter the codes in hexadecimal format and use spaces to separate
the codes.
2. Each code should have at most 2 characters (0-9, A-F or a-f).
3. Please do not use codes 00 or 02 as they are reserved by the program.
iv. Layer Index
Layers are useful in programming different codes to the same key. The output of
the codes will be determined by the layer index which can be selected by another
key programmed with the appropriate layer index code. There are at most 16
different programmable layers. You can assign a layer index to any programmable
key you like.