Owner's manual
4 5
ENGLISH
USING THE CONSOLE
• The top display (RPM) shows Cadence in RPM, average RPM and Low battery indicator. Cadence in RPM is the
pedalling speed. The AVG (average) indicates the average value since the start of the exercise.
• The Middle display (HEART RATE) shows heart rate, session Average and % of maximum heart rate. The heart
rate is presented in beats per minute. AVG (average) indicates the average value since the start of the exercise.
The % of MHR display indicates exercise intensity using the formula 220-age to represent 100%, and then current
heart rate as a percentage of the maximum.
• The bottom display (TRAINING) shows the following data:
TIME: exercise session time.
DISTANCE: the equivalent distance that would have been covered when cycling on the road. To change which
data is being shown press the Mode key ( ).
• To start and pause the time, press ( ). To reset the timer, press and hold the Mode key ( ). This can be
done when displaying any TRAINING session.
• SCAN feature:
To use the SCAN feature, press the Mode key ( ) 3 times until (SCAN) appears in the TRAINING display. This
will automatically change between TRAINING data in intervals of 3 seconds showing: DISTANCE, TIME and KCAL.
To stop the SCAN feature press the Mode key ( ). The SCAN symbol should have disappeared.
ENGLISH
7) Press Set key (
*
) after each digit has been paired to the
transmitter.
PAIRING SPEED TRANSMITTER TO CONSOLE
1) Remove the battery from the console and the display should go blank.
2) Insert the same battery again while pressing and holding any key. The
display will now show the maintenance screen.
3) Press the Set key (
*
), which will show (SPD) in the middle display and (E01)
in the top display.
4) Press Set key (
*
), which will show (SPD) in the middle display, 0 (RPM) in
the top display and (0000) in the bottom display.
5) To pair automatically, press Mode key ( ). The 4 digit alphanumeric
should match the code on the side of the cadence transmitter.
6) To pair manually, press and hold the Mode key ( ). The rst digit of
the 4 digit code (0000) should be ashing. Adjust the digit using the up/
down keys (
).
8) Press Set key (
*
) and
select distance in (KM) or
(Miles) by using the Up/
Down keys (
).
9) Press Set key (
*
) and
set the Gear Ratio to 1.0
by using the Up/Down
keys (
).
10) Press Set key (
*
) to nish and begin exercise.
MX18_OM_CXC_console_r1_1_A.indd 4-5 3/1/18 8:43 AM