Specifications

Once in the command line interface (CLI) type "telnet", the IP address

of the unit you wish to control and "23", then hit enter.

Note: The IP address of the Matrix can be displayed on the device's

LCM monitor by pressing the Menu button twice/three times.

This will bring us into the device which we wish to control. Type "HELP"

to list the available commands.

Type “IPCONFIG” To show all IP congurations. To reset the IP, type

“RSTIP” and to use a set static IP, type ”SETIP”.

Note: Any commands will not be executed unless followed by a

carriage return. Commands are not case-sensitive. If the IP is changed

then the IP Address required for Telnet access will also change

accordingly.