Instruction Manual

10
MAINTENANCE SCHEDULE
ACTION FREQUENCY
Clean and inspect the ClimbMill:
Turn o the machine with the ON/OFF switch, then unplug the power
cord at the wall outlet.
Clean entire machine using water and a mild soap applied to a soft
cloth. Never use solvents, as they can cause damage to the ClimbMill.
Never spray cleaner directly onto the machine or console.
Inspect the power cord. If the power cord is damaged.
Make sure the power cord is not underneath the machine or in any
other area where it can become pinched or cut during storage or use.
If any labels are damaged or illegible.
BEFORE EACH USE
Clean underneath the machine:
Turn o the machine with the ON/OFF switch, then unplug the power
cord at the wall outlet.
Remove the service cover from the front of the machine by the 2
screws and wipe or vacuum any grease, dust particles or other objects
that may have accumulated on any surface. Return the service cover to
its previous position.
Wipe or vacuum any dust particles or other objects that may have
accumulated around the machine.
WEEKLY
Unplug the ClimbMill and clean the AUTO STOP SENSORS (located under
the bottom step).
WEEKLY
IMPORTANT!
Turn o the machine with the ON/OFF switch, then unplug the power
cord at the wall outlet. Wait 60 seconds.
Inspect all assembly bolts of the machine for proper tightness.
Reference assembly steps for proper tension of each bolt.
Remove the front access cover. Wait until ALL LED lights turn o.
Clean the area to eliminate any lint or dust particles that may have
accumulated. Failure to do so may result in premature failure of key
electrical components.
Check step motion by rotating the steps backwards to ensure free
movement.
Check stability to ensure the ClimbMill does not rock or wobble. Adjust
levelers as necessary.
MONTHLY
MAINTENANCE
Preventative maintenance is the key to smooth operating
equipment, as well as keeping the users’ liability to a minimum.
Equipment needs to be inspected at regular intervals. Defective
components must be replaced immediately. Improperly
working equipment must be kept out of use until it is repaired.
Ensure that any person(s) making adjustments or performing
maintenance or repair of any kind is qualified to do so.
MAINTAIN LABELS AND NAMEPLATES: Do not remove labels
for any reason. They contain important information.
WARNING
Disconnect all power before servicing or moving the equipment.
To remove power from the ClimbMill, the power cord must be
disconnected from the wall outlet. To clean, wipe surfaces down
with soap and slightly damp cloth only; never use solvents.
AUTO STOP SENSORS
ENGLISH