Owner`s manual

14 15
RECOMMENDED CLEANING TIPS
Preventative maintenance and daily cleaning will prolong the life and look of your equipment.
SOLUTION: Follow these tips:
• Position the equipment away from direct sunlight. The intense UV light can cause discoloration on plastics.
• Locate your equipment in an area with cool temperatures and low humidity.
• Clean with a soft 100% cotton cloth.
• Clean with soap and water or other non-ammonia based all purpose cleaners.
• Wipe foot pads, handles, heart rate grips, and handlebars clean after each use.
• Do not pour liquids directly onto your equipment. This can cause damage to the equipment and in some cases electrocution.
• Check pedal motion and stability.
• Adjust leveling feet when equipment wobbles or rocks.
• Maintain a clean area around equipment, free from
dust and dirt.
CHECK FOR DAMAGED PARTS
DO NOT use any equipment that is damaged or has worn or broken parts. Use only replacement parts supplied by Matrix Fitness.
MAINTAIN LABELS AND NAMEPLATES. Do not remove labels for any reason. They contain important information. If unreadable
or missing, contact Matrix Fitness Systems for a replacement. 1-866-693-4863, www.matrixfitness.com
MAINTAIN ALL EQUIPMENT Preventative maintenance is the key to smooth operating equipment. Equipment needs to be
inspected at regular intervals. Defective components must be replaced immediately. Improperly working equipment must be kept out
of use until it is repaired. Ensure that any person(s) making adjustments or performing maintenance or repair of any kind is qualified
to do so. Matrix Fitness Systems will provide service and maintenance training at our corporate facility upon request or in the field if
proper arrangements are made.
CARE AND MAINTENANCE
HOW DO I CLEAN MY MACHINE?
Clean with soap and water cleaners only. Never use solvents
on plastic parts. Cleanliness of your stepper and its operating
environment will keep maintenance problems and service calls to
a minimum. For this reason, Customer Tech Support recommends
that the following preventive maintenance schedule be followed.
DAILY
• Clean entire machine using water and mild detergent such as
“Simple Green”, or other Matrix approved solution (cleaning
agents should be alcohol and ammonia free).
To remove power from the equipment, the power cord
must be disconnected from the wall outlet.
WARNING
PREVENTATIVE MAINTENANCE CHECKLIST
Facility:
MAKE: MODEL: S/N
LOCATION: TECHNICIAN: DATE:
Inspect power cords
Vacuum/clean under cover
Check resistance system
Lubricate pivot points
Check connecting joints
Notes/comments
Remove covers, check belts
Verify electronics operation
Check pulleys
Check/tighten hardware
QUARTERLY
• Check all connecting joint areas for tightness of
bolt assemblies.
• Ensure that there is little, or no free play at all joint
assemblies once bolts have been tightened. Installation of
washer kits may be required if free play does not come out
from tightening bolts.
climber_om_r1.7.indd 14-15 9/30/11 12:01 PM