User manual

BACNET CONFIGURATION
3-8 MATRIX BACnet Router User Manual (6/6/2007)
3.5 BACNET
BACnet is used to configure Matrix Router’s BACnet device communication and routing parameters.
Within BACnet, the Router configuration section provides a method to allow configuration of the Device
Instance of Matrix Router, as well as router port numbers and other associated information.
Figure 3-5 Matrix Router BACnet Router Settings
Table 3-2: Matrix Router BACnet Router Settings
Variable Values Notes
Device Name alphanumeric
characters
(recommended limit of
32 characters)
Specifies a unique Device Name for Matrix Router.
This value should be unique throughout your entire BACnet
network, as it is commonly used to specifically identify the
device among a populated network.
BACnet Device
Instance
Number
0 - 4,194,303 Specifies the unique global Device ID for Matrix Router and
defaults to a value of 100.
This value must be unique throughout your entire BACnet
network and cannot match any other device, as it is used to
specifically address the unit for interrogation by other devices
such as front-ends.
BACnet Ethernet
Interface
Yes / No Specifies if BACnet over Ethernet routing is enabled. This
value should be set to Yes in the event that the BACnet IP
Interface option is set to No.
BACnet Ethernet
Network Number
1 - 65534 Specifies the network number for your BACnet over Ethernet
network. Each interconnected BACnet network must have a
network number that is unique throughout the internetwork.