Owner`s manual

12
6.2 MANAGER SCREEN DESCRIPTIONS
• P0: Maximum progam time -
Sets the total run time of any program.
• P1: Default workout time -
Workout time when QUICK START is pressed or when no time is
selected during program set up.
• P2: Default resistance level -
Starting resistance when QUICK START is pressed or no resistance
level is selected during program set up.
• P3: Default user weight -
Weight used for program calorie expenditure calculations.
• P4: Speed Units - Display value in miles or kilometers.
• P5: Machine Type -
The Console is shared on the A3x. A3x default setting is “SWING”.
• P6: Console beep on / off - Confirmation beeps can be turned on or off.
• P7: Accumulated distance - Total distance of all programs.
• P8: Accumulated time - Total accumulated program time displayed in hours.
• P9: Display language -
Select between English, Spanish, French Italian, Dutch and German.
• P10: Software version -
Current version of software. Refer to this when calling Matrix Technical Service.
• P11: Incline calibration (A3x only) -
Default display is OFF. Selecting ON will automatically calibrate the
incline motor (s) to factory settings. Use this feature when actual
elevation does not match console display.
• P12: Incline Reset (A3x only) -
This is a software feature that resets machine elevation to 0 degrees
after 30 seconds of user inactivity. During incline reset, movement
can be stopped by pressing any console key. Display will scroll “HOLD
SELECT TO RESUME”. To resume reset to 0 degrees, hold “SELECT”key
for three seconds.
• P13: Default incline level (A3x only) -
Starting incline level at each program start except FIT TEST.
Factory setting is 10%. In FIT TEST, elevation is set to 0%.
• P14: Error Code -
Console will record up to three errors. Error codes are stored permanently
unless reset by a technician. To reset error codes, hold MANUAL and
RANDOM keys for three seconds. Refer to these error codes when
calling Matrix technical service for assistance.
• P15: LCB Version -
Display will show LCB.VER XX YYY.
XX is machine type.
YYY is version number.
6.1 USING MANAGER MODE
• To enter manager mode, hold the UP and DOWN level keys for three
seconds until “MANAGER” appears on the middle LED display.
• Press the UP and DOWN elevation keys to scroll between program screens.
• Press SELECT to modify program setting.
• Press UP or DOWN level keys to change value.
• Press QUICK START to save setting.
• Press QUICK START again to exit manager mode.
(example changing default time from 20:00 - 30:00 minutes).
CHAPTER 6: P
rogramming & engineering mode
Level
start
Incline
Time Speed Distance Elevation
Calories RPM Watts
Heart Rate
select
Select screen
Hold to reset
Quick start

Level
start
Incline
Time Speed Distance Elevation
Cal ories RPM Watts
Heart Rate
select
Select screen
Hold to reset
Quick start
S
t
a
r
t
p
e
d
a
l
i
n
g
t
o
v
i
e
w
o
p
e
r
a
t
i
n
g
i
n
s
t
r
u
c
t
i
o
n
s
Level
start
Incline
Time Speed Distance Elevation
Cal ories RPM Watts
Heart Rate
select
Select screen
Hold to reset
Quick start
Level
start
Incline
Time Speed Distance Elevation
Cal ories RPM Watts Heart Rate
Select screen
Hold to reset
Quick start
select
Level Incline
Time Speed Distance Elevation
Cal ories RPM Watts Heart Rate
Select screen
Hold to reset
Quick start
start
select




A3x_E3xc_rev1.7.indd 12 8/6/10 2:34 PM