User Manual

Page | 8
Multi-Zone Function
To Enable Multi Zone Feature
The WS90ti system is factory set to default mode.
In default mode; If more WS90t’s are added to the network, the remote will
control all speakers within the network simultaneously, if within transmitter
range.
By using the multi zone feature on the remote control, volume and source
selection can be independently controlled for each zone. The same source
device serving different zones.
The volume of the speakers in each zone can now be independently
controlled.
The speaker can be reset to default setting at any time by powering on, then
holding the YELLOW mute button for more than 5 seconds, the LED will
flash intermittently then power off. The speaker will be in the default setting
when next turned on.
Default mode can also be set by holding down the Station button on the
back of the speaker for more than 5 seconds after turning the speaker on.
To set multi- zone - power on the system by pressing the RED button on the
remote control. Press and hold down the zone to be set (A B or C) within
ten seconds of powering on.
Hold down the desired zone button (A B or C) for more than 5 seconds.
The LED will blink when the zone has been set. Repeat the process for the
speakers in another zone and choose another zone button.
Tip! This function can also be used on one set of speakers to allow Left /
Right speaker balance to be controlled. Follow the instructions above but
set one speaker at a time.
STATION CODE BLUE