User's Manual

NEG(-)
REVERSE POLARITY
WILL DAMAGE UNIT
POWER
STATUS
S
4
S
3
S
2
S
1
LOAD
LEVEL
BREAKER
POS(+)
DC INPUT
AC INPUT
1
0
INPUT
LEVEL
0
I
PORT
REMOTE
ON-OFF-REMOTE
POWER
4. Introduction:
4-1.Inverter Operation
Switch the power ON, then the power inverter is ready to supply AC power to
the loads. Turn on the loads separately after the inverter is ON to prevent
OVP status caused by the surge power.
4-1-1. Switch the power ON, then the buzzer will send out beep sound. At the
moment, the inverter is doing self-diagnosis. Then the LED’s indicators
will also show various colors.
Finally, the buzzer will send out another beep, and the Input Level and
Status LED indicators will turn green. Then the inverter will start to
work.
4-1-2. Switch the power OFF, then the inverter stops and all the lights that are
On will go Off.
4-1-3. Switch the power inverter and the test load ON, then the inverter will
supply the power to the load. If you want to measure true RMS voltage
output of the inverter, a meter such as FLUKE 45 BECKMAN 4410 or
TRIPLETT 4200 must be used.
4-2. Front Panel Operation
4-2-1. Front view：
18