Manual

1. Power off the display module.

2. Place a Jumper on the Manual Override pins.

3. Power up the display module.

4. The display module is now set to its default values listed below in table 2.

5. Edit and save settings.

Figure 20: Manual Override Jumper

Table 2: Default Values

Brightness 0x03

Baud Rate 19.2 kbps

C Slave Address 0x50

Data Lock False

RS232AutoTransmitData True

NOTE The display module will revert back to the old settings once turned off, unless the

settings are saved.

Matrix Orbital VK204-25 14