Instruction Manual

Description This command turns auto repeat mode off. See Set Auto Repeat Mode.
Remembered No
9.10 Assign Keypad Codes
Syntax
Hexadecimal 0xFE 0xD5 [KDown] [KUp]
Decimal 254 213 [KDown] [KUp]
Parameters
Parameter Length Description
KDown 25 Key down codes
KUp 25 Key up codes
Description This command will allow you to reassign the key codes that correspond
to the key presses on the matrix style key pad. The first 12 bytes that are
transmitted will be used for the key down codes and the next 12 bytes
that are transmitted will be used for the key up codes. The default values
of the key down codes are ’A-Y’ in order, and for the key up codes the
values are ’a-y’ in order.
Key Down
1 2 3 4
1 A B C D
2 E F G H
3 I J K L
Key Up
1 2 3 4
1 a b c d
2 e f g h
3 i j k l
Remembered Always
10 Display Functions
10.1 Introduction
The PK162-12 employs software controlled display settings, which allow for control over, clearing the
screen, changing the brightness and contrast or setting timers for turning it on or off. The combination of
these allow you complete software control over your display’s appearance.
10.2 Display On
Matrix Orbital PK162-12 40