Instruction Manual

Description Disabling Auto Line Wrap will allow you to have full control over the
cursor position. This means that once the cursor has advanced to the
end of a line, it will not wrap over to the next line, unless given the ’Set
Cursor Position’ Command.
NOTE All characters written to the display past the end of a line will be lost.
Remembered Yes
5.8 Set Cursor Position
Syntax
Hexadecimal 0xFE 0x47 [col] [row]
Decimal 254 71 [col] [row]
ASCII 254 “G” [col] [row]
Parameters
Parameter Length Description
col 1 Column
row 1 Row
Description This command will allow you to manually set the cursor position, which
controls the text insertion point, by specifying the [col] and [row] of the
new proposed cursor position.
NOTE If the cursor position is set past the end of a line it will wrap to the beginning of
the next line.
Remembered No
5.9 Go Home
Syntax
Hexadecimal 0xFE 0x48
Decimal 254 72
ASCII 254 “H”
Description This command will return the cursor to the top left corner of the display
area, identified as row one, column one.
Matrix Orbital PK162-12 21