Quick Guide
Table Of Contents
- Safety and Compliance Information
- Regulatory Compliance
- FCC statements
- Battery Directive-2013/56/EC
- Default IP, Username and Password
- The default password is used for your first login. To ensure account security, please change the password after your first login. You are recommended to set a strong password (no less than eight characters).
- Packing List
- Appearance
- Mount Your Camera
- The preceding installation process is for concealed installation, during which holes are punched on the wall and cables are penetrated into the wall. If open installation is adopted, cables are not penetrated into the wall but threaded out from the outlet on one side of the base.
- Access Your Camera
11
Open your browser, input the IP address of your camera in
the address bar and then press Enter to open the login page.
Enter the username and password and then click Login.
Install the ActiveX at your first login. When the
installation of the ActiveX is completed, open your
IE to log in.
For your first login with Windows 7, if the system
does not prompt you to install ActiveX, follow these
steps to turn off UAC: click the Start button, and
then click Control Panel. In the search box, type
uac, and then click Change User Account Control
Settings. Move the slider to the Never Notify
position, and then click OK. After UAC is turned off,
log in again.
If the installation failed, open Internet Option in IE
before login. Click the Security tab, click Trusted
sites, and then click Sites to add the website. If you
use Windows 7, you need to save the setup.exe to
your PC first, and then right-click the file, select Run
as administrator, and then install it according to
instructions.