User Manual- ML-9

Matrix Light ML-9 LED Ring Light ••• 21
••• USING AND CHARGING THE BATTERY
How to use and charge the battery •••
1. Connecting ML-9 LED Light to Battery
a. Connect the power cable (ML-PC1) to the battery's DC power jack.
b. Connect the other end of the power cable (ML-PC1) to the LED Light's
power connector.
c. Turn on the ML-9 LED Light.
2. Charging the battery
a. Unplug the power cable (ML-PC1) from the battery's DC power jack.
b. Plug the battery charger (ML-CHG1) into an AC outlet. Connect the
charger plug to the battery's DC power jack. When charging the battery
the charger's indicator LED turns red.
c. When the battery is fully charged the charger's indicator LED turns from
red to green. Unplug the battery charger (ML-CHG1) from the battery fully
charged.
⚠ Warning: Only use the designated battery charger (ML-CHG1). Using other chargers can
damage the battery and create explosion hazard.
⚠ Caution: If the battery’s DC terminals are shorted out by a metallic object, the battery's short
circuit protection system cuts off the battery's power immediately. To reactivate the
battery, simply charge the battery for a few seconds.