User Manual- ML-9

Matrix Light ML-9 LED Ring Light ••• 16
⚠ Caution: Using turbo mode reduces the battery life by half and may increase the fan noise.
5. Mini-USB connector
The two mini USB connectors located at the bottom of the light are
communication ports that receive or send synchronization signals. This
allows convenient control over multiple units in light stand or studio
settings. When the lights are connected by ML-CX1 mini 5-pin cables,
each of the lights are synchronized, so changes in brightness or color
temperature settings on one unit is applied to the rest of the lights in the
chain. Also, if one unit is turned off, the other units will also turn off. For
example, in the multiple units connected by USB cable as shown below,
when you change no. 1 light’s brightness, and color temperature, the rest
units operate the same as no.1 light.
6. Cooling fan control
The cooling fan on the ML-9 only comes on when the internal temperature
reaches a certain point, except when Turbo Mode is activated, in which case
the fan operates continuously.
⚠ Turbo Mode provides high light output but also increases the noise from continued cooling
fan operation.
⚠ Turbo Mode decreases battery life to approximately 1.5 hours. Prolonged use in Turbo Mode
may reduce the life of the LED elements.
Installation on an ENG Camera •••