User Manual- ML-9

Matrix Light ML-9 LED Ring Light ••• 18
4. Tighten the screw on the ML-LB2 Ball-head Bracket once the light is
adjusted correctly.
5. To synchronize the light and the ENG camera’s Cue/Cut button, turn the
light on, and set the ENG camera to Auto mode. Then set the light to the
Auto mode pressing the light’s Power switch for 3 seconds. To switch to the
Manual mode, press Power switch for 3 seconds again.
Installation on a Camera using supplied Battery •••
1. For use with cameras without a 12V DC output, such as SONY’s PMW-
EX1R or Canon’s 5D Mark III, the supplied battery (ML-BA12) must be used.
2. To use supplied battery, fasten the battery to the camera using the Tripod
Adapter (ML-AT1) and the L-bracket Slide (ML-SL30). Start by installing the
Tripod Adapter (ML-AT1) to the camera using the screw at the bottom of the
adapter.