User Manual - Ring Light

Matrix Light ML-115R LED Ring Light ••• 9
 Safety and Warnings about Light Installation / Maintenance
⚠ Do not install in the places with excess oil, smoke, dampness, dust, or
rainwater.
⚠ If the inside of the device is exposed to oil and/or dampness, it may cause
an electrical shock and/or a fire.
⚠ Do not switch on the light close to the eyes on people or animals. Doing
so can damage their vision. Be especially careful when filming infants. Do
not point the light directly at their eyes and keep the light at least 2 meters
away and always apply the diffuser(ML-DF2).
⚠ Do not switch on the light towards vehicle operators. Doing so can distract
them and may cause an accident.
⚠ Do not block the front panel or vent of the light. It will degrade the life of
LED module by raising the internal temperature and may cause a fire.
⚠ Use only designated batteries as the power source. Using other power
equipment can cause malfunctions and creates a risk of fire.
⚠ After using the light for five or more minutes, do not put your hands on
the light for a long time. If you do, you may get a low-temperature burn.
Please handle the light after cool down in case of overheating.
⚠ In case of water damage or case damage, turn off the power and unplug
the light. Do not attempt to power on the light again as it may cause an
electrical shock or a fire. Please contact a service center immediately.
⚠ Do not dismantle or modify the light. Doing so can cause an electric shock
and is a fire hazard. If in need of repair, call a service center.
⚠ Do not store or use explosive spray or flammable substances near the
light. Doing so can create an explosion and fire hazard.
⚠ Do not insert metal or flammable substances such as chopsticks, wires,
gimlets, paper, or matches into cooling vents or DC Power jack. Doing so