User Manual - Ring Light

Matrix Light ML-115R LED Ring Light ••• 18
2. If installing the lens is difficult, install the light to the camera shoe using
ML-LB3 ball-head bracket, and ML-EB1 extension bar as shown as below.
If the camera’s shoe is a male type, please use the shoe converter(ML-
MSC1), or the screw (ML-SCR1).
3. Use the ML-PT1 power cable to connect the light to the 12V DC output
on the camera, or use Power Tap Connecter (ML-PT3) to connect the light
to the battery pack or 12V DC output port in V Mount Adaptor. Please
ensure the polarity of the power cable is correct. When the polarity is
switched, the light might not come on, or it causes malfunction.
4. To synchronize the light and the ENG camera’s Cue/Cut button, turn the
light on, and set the ENG camera to Auto mode. Then set the light to the
Auto mode pressing the light’s Power switch for 3 seconds. To switch to