Installation Guide

INSTALLATION OF THE FAUCET
1! New Faucet Preparation
Shut off the water supply. Remove the old
faucet by disconnecting the supply tubes
under sink and then unscrewing the faucet
from the counter top by removing the
mounting nuts. Clean the sink top surface
in preparation for the new faucet.
2
Install Faucet on Sink Top
Place the faucet in position on the sink top
and screw nuts and washers upward from
under the sink onto faucet connectors.
Tighten the nuts alternating until they are
nearly flush with the underside of the sink
top. Then, align the faucet as desired.
While maintaining set alignment, tighten
do
wn lock nuts to lock fauce
t into place.
Note: lever handles should turn towards
front of faucet for proper operation.
3 Install Faucet Hoses
If you have a hose supply that is long
enough to reach the faucet lines, assemble
as follows: slide water supply hose into
flush position. Hose will go partially into
nuts, then use a wrench to hold the hoses
securely into place. Plumbers Tape may be
used to help prevent leaks.
4 Remove Aerator and Flush
!
!
!
!
!
!
!
!
!
!
!
!
Once installation of hoses is complete,
remove the aerator. Turn the water supply
on and allow both hot and cold water to
run for 30 to 60 seconds. While water is
running, check for leaks around and under
the sink. Once done replace aerator. Your
Lordear faucet is ready to use.
MAINT E NANCE AND CLEA NING
Cleaning Tips: The finish on your product
is designed to retain its beautiful sheen
for years. To maintain the original look of
the finish, a little care and caution should
be used. We recommend the use of mild
soap and water to clean the product.
THE USE OF ABRASIVE CLEANERS MAY
SCRATCH THE FINISH OR CAUSE
OTHER DAMAGE.
RECOMMEN D ED TOOLS A ND
MATERIA L S
! Adjustable Wrench
! Plumbers Tape (Thread Seal
Tape)
BEFORE Y OU B EGIN
There
are a variety of things to do before
installing any new plumbing system into
your home or residence. Before you begin
work make sure you:
! Shut off the main water supply
! Cover your drain to prevent
loss of parts
! Observed any local plumbing
codes
! Inspect fixture for damage -
Replace as necessary
Lordear reserves the right to make any
revisions in the design of products without
notice.
1. Stainless Steel BAS
E (2)
2. Stainless Steel Handle (2)
3. POM Bold (2)
4. Stainless Screws (2)
5. POM Inner Sleeve (2)
6. POM Nut (2)
7. Brass Spout
8. Stainless Steel Spout Nut
9. POM C Buckle
10. Rubber O-Ring
11. Stainless Steel Escutcheon
12. POM/Rubber/Stainless Mandrel 2
13. Rubber Washer (2)
14. Stainless Spring (2)
15. POM/Rubber Body
16. PP Base Plate
17. Rubber Washer (2)
18. ABS Mounting Nut (2)
19. Rubber Washer (2)
20. ABS Coupling Nut (2)
21. Rubber Washer
22. POM Flow Restrictor
23. POM Filter Nut
24. POM Ring
25. Stainless Filter
26. POM Filter Seat
27. Stainless Steel Aerator Nut
Package Includes：
1x PC Kitchen Sink Faucet
1x PC Hot & Cold Water Supply Hoses