Installation Guide

① Tub spout
② BATH and SHOWER switch
③ hand shower
④ Hot and cold water switch
⑤ shower holder
TIPS:
① Red as hot water pipe, Blue as cold water pipe
② Cleaning the hot and cold water inlet pipe to prevent debris from entering the inside,
damaging the valve body and affecting the use.INSTALLATION STEPS
1. Take the tub faucet set in the corresponding hole on the bathtub.
Fix the faucet body to the pipe. And put the base cover over the base.
2.Screw the pipe to the corresponding base
① Install the flexible hose and ensure the flexible hoses are hand tightened into
place. The flexible hoses are to be fitted into the correct inlets for hot water and for
cold water.(DO NOT USE SPANNER TO
TIGHTEN AS IT CAN DAMAGE THE O-RING)
② Connect another side of the flexible hose to the water supply pipe. Make sure
they are to be fitted into the correct outlets for hot water and cold water
③ Connect the shower hose and hand shower.
3. Finish
The hole is
35cm
The hole is
35cm
The hole is
35cm
The distance between the mounting parts can be adjusted according
to the actual situation
HOT
COLD
Gravity ball
⑥ Hot and cold water inlet pipe
⑦ Connecting pipe
⑧ 1.5m Shower hose
⑨ Gravity ball(251g)
（ ）
（ ）