Quick Installation Guide

37
At the end of product life cycle; batteries, soldered boards,
metal components and plastic components must be disposed
through recyclers.
If you are unable to dispose-off the products or unable to
locate e-waste recyclers, you may return the products to
Matrix Return Material Authorization (RMA) department.
Disposal of Product after End-Of-Life
The product refered is covered by the waste Electrical and
Electronic Equipment (WEEE) directive and must be disposed
of in a responsible manner.
WEEE Directive 2002/96/EC
www.matrixaccesscontrol.com
Head Office
394-GIDC, Makarpura, Vadodara, Gujarat, 390010, India
Ph: ([phone]
Email: [e-mail]
MATRIX COMSEC PVT. LTD.
V 1.3, March 2021
FCC
FCC Compliance
This device complies with part15 of the FCC rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits of
Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct
the interference at his own expense.
Warning
This is a Class A product. In a domestic environment this product may
cause radio interference in which case the user may be required to
take adequate measures.
Certification in-progress for ATOM 200/300
Caution:
Any Changes or modifications not expressly approved by
the party responsible for compliance could void the user's
authority to operate the equipment.
FCC RF Radiation Exposure Statement:
1. This Transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
2. This equipment complies with RF radiation exposure
limits set forth for an uncontrolled environment.
3.This equipment should be installed and operated with
minimum distance 20cm between the radiator& your body.