User guide

51
GlobalFiler
™
Express PCR Amplification Kit User Guide
Chapter4 Analyze Data
Set up GeneMapper
®
ID-X Software for data analysis
4
GeneMapper
®
ID-X Software
Create an analysis
method
Use the following procedure to create an analysis method for the GlobalFiler
™
Express
Kit.
IMPORTANT! Analysis methods are version-specific, so you must create an analysis
method for each version of the software. For example, an analysis method created for
GeneMapper
®
ID-X version 1.2 is not compatible with earlier versions of
GeneMapper
®
ID-X Software or with GeneMapper
®
ID Software version 3.2.1.
1. Select ToolsGeneMapper
®
ID-X Manager to open the
GeneMapper
®
ID-X Manager.
2. Select the Analysis Methods tab, then click New to open the Analysis Method
Editor with the General tab selected.
The figures below show the settings for each tab of the Analysis Method Editor.
Configure the Analysis Method Editor tab settings as shown in the figures below,
unless the instructions state otherwise.
Note: The Analysis Method Editor closes when you save your settings. To
complete this step quickly, do not save the analysis method until you finish
entering settings in all of the tabs.
3. After you enter settings in all tabs, click Save.