User`s guide

3 Signals and Parameters
The target screen plots the signals after collecting each data package.
During this time, you can observe the behavior of the signals while the
scope is running.
7 Stop the scope. Type either
-sc1
or
sc1.stop
or
stop(sc1)
The signals shown on the target PC stop updating while the target
application continues running, and the target PC displays the following
message.
Scope: 1, set to state 'interrupt ed'
8 Stop the target application. In the MATLAB window, type either
-tg
or
tg.stop
or
stop(tg)
The target application on the target PC stops running, and the target PC
displays the following messages.
minimal TET: 0.000023 at time 1313.789000
maximal TET: 0.000034 at time 407.956000
3-44