User`s guide

3 Signals and Parameters
Your next task is to add signals to the scopes. The following procedure
assumes that you have added scopes to the target PC and host PC.
Adding Signals to Scopes
This topic describes how to add signals using the xPC Target Explorer Add
to Scopes command. If a s cope does not exist, you can drag a signal to a
Host Scope, Target Scope, or File Scope icon to create a scope of that type in
xPC Target Explorer.
1 In the xPC Target Explorer w indow , add sig nals to the targ et PC scope,
Scope 1. For example, to add signals Int egrator1 and Signal Generator,
right-click each signal and select Add to Scopes.FromtheAdd to
Scopes list, select
Scope 1. (Note that you can also drag the signal to the
scopetoaddthesignaltothatscope.)
The
Scope 1 node is shown with a plus sign.
2 Expand the Scope 1 node.
The
Scope 1 signals are displayed.
If one o f the signals has been labeled. you can hover over the signal to
display the signal label. For exa mple,
3-24