User`s guide

setxpcenv
Environment Property Description
TcpIpTargetISAIRQ
Value is 'n',wheren is between 4 and 15.
If you are using an ISA bus Ethernet card, you must
enter values for the properties
TcpIpISAMemPort and
TcpIpISAIRQ. The values of these properties must
correspond to the jumper settings or ROM settings on the
ISA-bus Ethernet card.
On your ISA bus card, assign an IRQ and I/O-port base
address by moving the jumpers on the card.
MathWorks recommends setting the IRQ to 5, 10, or
11.If
one of these hardware settings leads to a conflict in your
target PC, choose another IRQ and make the corresponding
changestoyourjumpersettings.
TcpIpTargetISAMemPort
Value is '0xnnnn'.
If you are using an ISA bus Ethernet card, you must
enter values for the properties
TcpIpISAMemPort and
TcpIpISAIRQ. The values of these properties must
correspond to the jumper settings or ROM settings on your
ISA bus Ethernet card.
On your ISA bus card, assign an IRQ and I/O port base
address by moving the jumpers on the card.
Set the I/O port base address to around 0x300. If one of
these hardware se ttings leads to a conflict in your target
PC, choose another I/O port base address and make the
corresponding changes to your jumper settings.
Version
xPC Target version n u m ber. Read only.
The function setxpcenv works simil arly to the set function of the
MATLAB Handle Graphics
®
system. Call the function setxpcenv with
an even number of arguments. The first argument of a pair is the
property name, and the second argument is the new property v alue
for this property.
18-138