User`s guide

set (scope object)
Property Description Writable
For scopes of type Host, this parameter
has no effect.
NumPrePostSamples
For scopes of type 'Host' or 'Target',
this parameter is the number of samples
collected before or after a trigger event.
The default value is 0. Entering a negative
value collects samples before the trigger
event. Entering a positive value collects
samples after the trigger event. If you set
TriggerMode to 'FreeRun', this property
has no effect on data acquisition.
Yes
NumSamples
Number of contig uo us sam ples captured
during the acquisition of a data package.
If the scope stops b efore capturing
this number of samples, the scope has
the collected data up to the end of
data collecti on, then has ze roes for the
remaining uncollected data. Note that
you should know what type of data you
are collecting, it is possible that your data
contains zeroes .
For scopes of type
'File',this
parameter w orks in conjunction with
the AutoRestart check box. If the
AutoRestart box is selected, the file scope
collects data up to Nu mber of Samples,
then starts over again, overwriting the
buffer. If the AutoRestart box i s not
selected, the file scop e collects data only up
to Number of Samples,thenstops.
Yes
ScopeId
A numeric index, unique for each scope.
No
18-120