User`s guide

getxpcenv
Environment P rope rty Description
TcpIpTargetDriver
Values are 'NE2000', 'SMC 91C9 X', 'I82559',
'RTLANCE', 'R8139', '3C 90x',and'NS83815'.
From the xPC Target Explorer window TcpIp target
driver list, select
NE2000, SMC91C9X , I82559, RTLANCE,
R8139, 3C90x,orNS83 815. The Ethernet card provided
with the system uses the
NE2000 driver.
TcpIpTargetPort
Value is 'xxxxx'.
In the xPC T arg et Explorer window TcpIp target
port box, enter a value greater than
20000.
This property is set by default to
22222 and should not
cause any problems. The number is higher than the
reserved area (
telnet, ftp, ...) and it is onl y of use on
the target PC.
TcpIpTargetISAIRQ
Value is 'n',wheren is between 4 and 15.
IfyouareusinganISAbusEthernetcard,youmust
enter values for the properties
TcpIpISAMemPort and
TcpIpISAIRQ. The v alues of these properties must
correspond to the jumper settings or ROM settings on
the ISA-bus Ethernet card.
On your ISA bus card, assign an IRQ and I/O-port base
address by moving the jumpers on the card.
MathWorks recommends setting the IRQ to 5, 10, or
11. If o ne of these hardware settings leads to a conflict
in your target PC, choose another IRQ and make the
corresponding changes toyourjumpersettings.
18-76