User`s guide

General xPC Target™ Troubleshooting
General xPC Target Troubleshooting
In this section...
“General I/O Troubleshooting Guidelines” on page 15-21
“Can I View the C ontents of the Target PC Display on the Host PC?” on
page 15-22
“Why D o Attempts to Run My Model Cause CPU Overload Messages on the
Target PC?” on page 15-22
“How Can I Reduce the TET in My Application?” on page 15-27
“How Can I Obtain PCI Board Information for My xPC Target System?” on
page 15-27
“What Sample Time Can I Expect from the xPC Target Software?” on
page 15-28
“Why Is My Requested xPC Target Sample Time Different from the
Measured Sample Time?” on page 15-29
“Why Did I Get Error -10: Invalid File ID on the Target PC?” on page 15-30
“Can I Write Custom xPC Target Device Drivers?” on page 15-31
“CanICreateaStand-AlonexPCTargetApplicationtoInteractwitha
Target Application?” on page 15-32
“Can Signal O utputs from Virtual Blocks Be Tagged?” on page 15-32
“Why Has the Stop Time Changed?” on page 15-32
“Why Do I G et a File System Disabled Error?” on page 15-33
“Can the Target PC Hard Drive Contain Multiple Partitions?” on page 15-33
“Why Does the getparamid Function R eturn Nothing?” on page 15-33
“How Do I Handle Register Rollover for xPC Target Encoder Blocks?” on
page 15-34
“Why Do I Get Compile Error When Compiling Models?” on page 15-35
General I/O Troubleshooting Guidelines
If you encounter issues using the xPC Target I/O drivers,
15-21