User`s guide

Installation, Configuration, and Build Troubleshooting
6 Create the boot disk or boot image.
7 Reboot the target PC.
8 Rerun xpctest.
If this procedure does no t resolve the issue, perform the following:
1 At the MATLAB command line, type updatexpcenv. For example,
updatexpcenv
2 Recreate the boot disk or image u sing xpcbo otdisk.
3 Reboot the target PC.
4 Rerun xpctest.
xpctest: Test 6 Fails
This test runs the basic target object constructor, xpc. This error rarely occurs
unlessanearliertesthasfailed.
To correct this, perform the following,
1 At the MATLAB command line, refer to and read the xpc reference page.
For example,
help xpc
2 Follow any guidance that might be helpful.
3 Reboot the target PC.
4 Rerun and check the results o f e arlier tests and make the necessary
corrections.
xpctest: Test 7 Fails
This test executes a target application (xpcosc ) on the target PC. T his test
will fail if you change the
xpcosc model start time to something other than 0,
15-17