User`s guide

Installation, Configuration, and Build Troubleshooting
xpctest: Test 4 Fails
First, follow the procedure in th e “Test 4, Build and Download Application” in
the xPC Target Getting Started Guide.
If you need m ore help with Test 4, check the following:
• Verify that a supported compiler is being used.
• If the communication between the host PC and target PC is TCP/IP, set the
host PC network interface card (NIC) card and hub to half-duplex mode.
Do no t set the mode to full-duplex mode.
• Verify the specified path to the supported compiler. You need only the root
path to the compiler, not the full path. If you incorrectly specify a path,
you might get the following error:
Error executing build command: Error using ==> make_rtw
Error using ==> rtw_c (SetupForVisual)
Invalid DEVSTUDIO path specified
or the following error:
Error executing build command: Error using ==> make_rtw
Error using ==> rtw_c
Errors encountered while building mod el "xpcosc"
with the following MATLAB Command Window error:
NMAKE: fatal error U1064: MAKEFILE not found and no tar get
specified
Stop.
To correct these errors,
1 Ensure that your compiler is properly installed. For example, all Microsoft
Visual com piler components must be in the Microsoft
®
Visual Studio
®
folder after installation.
2 At the MATLAB prompt, type
xpcexplr
15-15