User`s guide

14 Vector CANape
®
Support
ThisisthetargetPCtowhichyouhavedownloadedthetargetapplication.
11 Ensure that the port number is 5555.
12 Click OK.
13 If you have Vector CANape Version 5.6.32.3 and higher, and you want to
use the xPC Target software to acquire event driven data:
a In the Driver pane of the XCP driver settings window, click Extended
driver settings.
b Set the ODT_ENTRY_ADDRESS_OPT_DISABLED parameter to Yes.
With this setting, events that are generated in the xPC Target
environment will be based on the model base sample time. For example,
a sample tim e o f 0.001 seconds will app e ar as 100 milliseconds.
c Click OK.
14 In the XCP driver settings window, verify the connection to the target PC
by clicking Test connection. This command succeeds only if the target PC
is running and connected properly. Be sure that no other host is connected
to the target PC.
15 Click OK.
The Device dialog is displayed.
16 Click Next.
Do not exit the dialog.
You can now configure the location of the target application A2L (ASAP2) file
for the CANape database. See “Configuring the Location of the A2L (ASAP2)
File” on page 14-9.
If you want to load a new target application, you must close Vector CANape,
download a new target application through the MATLAB interface, then
restart Vector CA Nape.
14-8