User`s guide

Configuring the xPC Target™ and Vector CANape
®
Software
Configuring the Vector CANape Device
This procedure describes how to configure the Vector CANape Device to w ork
with your target applicat ion. It assumes th e following:
• You have created a new Vector CANape project to associate with a
particular target application. If youhavenotyetdoneso,see“Creating
a New Vector CANape Project to Associate with a Particular Target
Application” on page 14-6.
• You have correctly set up, built, and downloaded your model. If you have
not yet done so, see “Setting Up and Building the Model” on page 14-4.
1 If you have not yet started your new V ector CANape project, start it now.
TheVectorCANapewindowisdisplayed.
2 In the CANape window, click Device > Device configuration.
The d evice confi gu ration win dow is displaye d.
3 In the device configuration window, click New.
4 In Device Name, enter a name for the device to des cribe yo ur target
application. For example, type
xPCTarget
Add a ny appropriate comments.
5 Click Next.
6 From the driver-type menu list, s elect XCP.
7 Click Driver settings.
The XCP driver settings window is displayed.
8 In the Transport layer pane, f rom the Interface menu list, select TCP.
9 In the Transport layer pane, click Configuration.
10 In the Host field, enter the IP address of your targe t PC .
14-7