User`s guide

11 xPC Target™ Web Browser Interface
Signals with a width greater than the value you enter are not displayed
on the Signals pane.
2 In the Refresh Interval box, enter a value greater than 10. For example,
enter 20.
Thesignalpaneupdatesautomatically every 20 seconds. Entering
-1 or
Inf does not automatically refresh the pane.
Sometimes, both the frames try to update simultaneously, or the auto refresh
starts before the previous load has finished. This problem can happen with
slow network connections. In this case, increase the refresh interval or
manually refresh the browser (set the Refresh Interv a l =
Inf).
Thiscanalsohappenwhenyouaretrying to update a parameter or p roperty
at the same time that the pane is automatically refreshing.
Sometimes, when a race condition occurs, the browser becomes confused about
the format, and you might have to refresh it. This should not happen often.
Viewing Signals with a Web Browser
The Signals pane is a list of the sign als in your model.
After you co nne ct a Web brows er to the target PC you can use the Signals
pane to view signal data:
1 In the left frame, click the Signals button.
The Signals pa ne is lo aded in the r ight frame with a list of signa ls and the
current values.
2 On the Signals pane in the right frame, click the Refresh button.
The Signals pane is updated with the current values. Vector/matrix
signals are expanded and i ndexed in the same column-major format that
the MATLAB interface uses. This can be affected by the Maximum Signal
Width value you enter in the left frame.
3 In the left frame, click the Screen Shot button.
11-10