User`s guide

3 Signals and Parameters
You next can use xPC Target Explorer or the MATLAB interface to work
with the tunable parameters.
Tuning Inlined Parameters with xPC Target Explorer
This procedure describes how you can tune inlined parameters through the
xPC Target Explorer. It assumes that you have built and downloaded the
model from the topic “Inlined Parameters” on page 3-79 to the target PC. It
also assumes that the model is running.
1 If you have not yet started xPC Target Explorer, do so now. Be sure it is
connected to the target PC to which you downloaded the
xpc_osc5 target
application.
2 To get the list of tunable inlined parameters in the target application,
expand the target application node, then expand the
Model Hierarchy
node under the target application node.
Note that the Model Hierarchy node displays a list of signals and an o bject
called
Model Parameters. Model Parameters contains the list of tunable
inlined parameters.
3 To display the tunable parameters, select Model Parameters.
The constant
A anditsvalueareshownintherightpane.
4 Double-click the box that contains the tunable parameter A.
The b ox becomes editable.
3-82