User`s guide

3 Signals and Parameters
The target application on the target PC stops running, and the target PC
displays the following messages:
minimal TET: 0.000023 at time 1313.789000
maximal TET: 0.000034 at time 407.956000
Parameter Tuning with a Web Browser
The Parameters pane displays a list of all the tunable parameters in your
model. Row and column indices for vector/matrix p aram eters are also shown.
After you connect a Web browser to the target PC, y ou can use the
Param ete rs page to change parameters in your ta rget application while it is
running in real time:
1 In the left frame, click the Parameters button.
The browser loads the Param eter List pane into the right frame.
If the parameter is a scalar parameter, the current parameter value is
showninaboxthatyoucanedit.
If the parameter is a vector or matrix, there is a button that takes you to
another page that displays the vector or m atrix (in the correct shape) and
enables you to edit the parameter.
2 Enter a new parameter value into one or more of the parameter boxes,
and then click the Apply button.
The new parameter values are uploaded to the target application.
Saving and Reloading Application Parameters with
the M ATLAB Interface
After you have a set of target application parameter values that you are
satisfied with, you can save thos e v aluestoafileonthetargetPC.Youcan
then later reload these saved parameter values to the same target application.
You can save parameters from your target application while the target
application is running or between runs. This feature lets you save and restore
parameters in your target application without rebuilding the Simulink
model. You save and restore parameters with the target object methods
saveparamset and loadparamset.
3-76