User`s guide

Using Environment Properties and Functions
5-17
Creating a Target Boot Disk with Graphical
Interface
You use the target boot disk to load and run the xPC Target kernel.
After you make changes to the xPC Target environment properties, you need
to create or update a target boot disk. To create a target boot disk for the
current xPC Target environment, use the following procedure:
1 In the MATLAB window, type
xpcsetup
The xPC Target Setup window opens.
2 Click the BootDisk button.
If you didn’t update the current settings, the following message box appears.
Click No. Click the Update button, and then click the BootDisk button
again.
After you update the current properties, and click the
BootDisk button, the
following message box appears.
3 Insert a formatted floppy disk into the host PC disk drive, and then click OK.
All data on the disk will be erased.
The write procedure starts and while creating the boot disk, the MATLAB
command window displays the following status information. On Windows