User`s guide

5 Environment Reference
5-12
Using Environment Properties and Functions
You use the xPC Target Setup window to enter properties that are independent
of your model.
This section includes the following topics:
Changing Environment Properties
•“Getting a List of Environment Properties”
•“System Functions”
•“Changing Environment Properties with Graphical Interface”
•“Changing Environment Properties with Command Line Interface”
Target Boot Disk
•“Creating a Target Boot Disk with Graphical Interface”
•“Creating a Target Boot Disk with Command Line Interface”
To enter properties specific to your model and its build procedure, see
“Entering the Simulation Parameters” on page 3-8. These properties are saved
with your Simulink model.
Getting a List of Environment Properties
To use the xPC Target functions to change environment properties, you need
to know the names and allowed values of the properties. Use the following
procedure to get a list of the property names, their allowed values, and their
current values:
1 In the MATLAB window, type
setxpcenv
MATLAB displays a list of xPC Target environment properties and the
allowed values. For a list of the properties, see “Environment Properties” on
page 5-3
2 Type
getxpcenv