User`s guide

5 Environment Reference
5-8
TcpIpTargetISAMemP
ort
Value is ’0xnnnn’.
If you are using an ISA-bus Ethernet card, you
must enter values for the properties
TcpIpISAMemPort and TcpIpISAIRQ. The
values of these properties must correspond to the
jumper settings or ROM settings on your ISA-bus
Ethernet card.
On your ISA-bus card, assign an IRQ and I/O-port
base address by moving the jumpers on the card.
We recommend setting the I/O-port base address
to around 0x300. If one of these hardware settings
leads to a conflict in your target PC, choose
another I/O-port base address and make the
corresponding changes to your jumper settings.
TcpIpTargetISAIRQ
Value is ’n’ where n is between 4 and 15.
If you are using an ISA bus Ethernet card, you
must enter values for the properties
TcpIpISAMemPort and TcpIpISAIRQ. The
values of these properties must correspond to the
jumper settings or ROM settings on the ISA-bus
Ethernet card.
On your ISA-bus card, assign an IRQ and I/O-port
base address by moving the jumpers on the card.
We recommend setting the IRQ to 5, 10, or
11. If
one of these hardware settings leads to a conflict in
your target PC, choose another IRQ and make the
corresponding changes to your jumper settings.
Table 5-1: List of Environment Properties
Environment
property
Description