User`s guide

Environment
5-7
TcpIpGateway
Value is ’xxx.xxx.xxx.xxx’.
In the Setup window
TcpIpGateway box, enter
the IP address for your gateway. This property is
set by default to
255.255.255.255 which means
that a gateway is not used to connect to the target
PC.
If you communicate with your target PC from
within a LAN that uses gateways, and your host
and target computers are connected through a
gateway, then you need to enter a value for this
property. If your LAN does not use gateways, you
do not need to change this property. Ask your
system administrator.
TcpIpTargetDirver
Values are ’NE2000’ or ’SMC91C9X’.
From the Setup window
TcpIpTargetDriver list,
choose either
NE2000 or SMC91C9X. The
Ethernet card provided with xPC Target uses the
NE2000 driver.
TcpIpTargetBusType
Values are ’PCI’ or ’ISA’.
From the Setup window
TcpIpTargetBusType
list, choose either
PCI or ISA. This property is set
by default to
PCI, and determines the bus type of
your target PC. You do not need to define a bus
type for your host PC, which can be the same or
different from the bus type in your target PC.
If
TcpIpTargetBusType is set to PCI, then the
properties
TcpIpISAMemPort and TcpIpISAIRQ
have no effect on TCP/IP communication.
If you are using an ISA bus card, set
TcpIpTargetBusType to ISA and enter values for
TcpIpISAMemPort and TcpIpISAIRQ.
Table 5-1: List of Environment Properties
Environment
property
Description