User`s guide

Stand-Alone Target Applications
4-17
It is necessary to edit the Scope (xPC) dialog box and confirm that the check
box entry for Start Scope after download is checked as shown in the
following dialog box.
This setting is required to enable target scopes to begin operating as soon as
the application starts running. The reason this setting is required is that the
host PC is not available in StandAlone mode to issue a command that would
start scopes. With these settings, click Build and copy the files from your
modelname_xpc_emb subdirectory to your boot disk. Then boot your target PC.
When the target application starts to run, the target scopes will start
automatically. A monitor is needed on your target PC to view the results.
Note When using target scopes with StandAlone mode, you must specify the
Scope Type as Target prior to generating code.