User`s guide

2 Advanced Procedures
2-16
6 Connect the xPC Target scope block with the Simulink scope block.
The model
xpcosc should look like the figure shown below.
Your next task is to define the xPC Target scope block parameters. See
“Defining xPC Target Scope Block Parameters”.
Defining xPC Target Scope Block Parameters
Scope block parameters define the signals to trace on the scope, trigger modes,
and the axis range.
This procedure uses the Simulink model
xpcosc.mdl as an example, and
assumes you have added an xPC Target scope block to your model. To add a
scope block, see “Adding xPC Target Scope Blocks” on page 2-13.
1 Double-click the scope block labeled Scope (xPC).
The Block Parameters dialog box for the scope block opens.