User`s guide

Scope Object
7-5
Decimation
A number n, where every nth sample is
acquired in a scope window.
Note This value is the same as Interleave
in a scope window.
Yes
TriggerMode
Trigger mode for a scope. Valid values are
’FreeRun’ (default), ’Software’,
’Signal’, and ’Scope’.
Yes
TriggerSignal
If TriggerMode=’Signal’, identifies which
block output signal to use for triggering
the scope. You identify the signal with a
signal index from the target object
property Signal.
Yes
TriggerLevel
If TriggerMode=’Signal’, indicates the
value the signal has to cross to trigger the
scope and start acquiring data. The trigger
level can be crossed with either a rising or
falling signal.
Yes
TriggerSlope
If TriggerMode=’Signal’, indicates
whether the trigger in on a rising or falling
signal. Values are
’Either’ (default),
’Rising’, or ’Falling’.
Yes
TriggerScope
If TriggerMode=’Scope’, identifies which
scope to use for a trigger. A scope can be set
to trigger when another scope is triggered.
This is done by setting the slave scope
property
TriggerScope to the scope index
of the master scope.
Yes
Mode
Indicates how a scope displays the signals.
Values are
’Numerical’, ’Redraw’
(default),
’Sliding’, or ’Rolling’.
Yes
Table 7-1: List of Scope Object Properties
Property Description Write