Specifications

Introduction
4-7
The following table shows which CAN-Library property value depending on the
used board or boards.
* the setting ‘1000 MB PCI’ is the same as ‘1000 PCI’ and is still supported in
order to provide backward compatibility to version 1.0 of xPC Target.
The environment setup allows to set one of the above property values. This does
imply that you cannot mix different types of Softing CAN-boards in the same
target system. For example you cannot use a CAN-AC2 (ISA) board together
with a CAN-AC2-PCI board in the same target PC (desktop). On the other hand
the xPC Target CAN-drivers support multiple boards of the same type
(CAN-AC2-PCI and CAN-AC2-104, but not CAN-AC2 (ISA)) in the same target
PC. For more information see the board specific driver block description.
After having chosen the right CAN-library push the “Update”-button to make
the current setting the actual setting. If this is the only property you have
changed in the environment setup the regeneration of the target boot floppy
disk is not necessary.
After this, close the xpcsetup-GUI. You are now ready to create the first target
application using CAN driver blocks
Board CAN-Library property value
CAN-AC2 (ISA) with Philips PCA 82C200
(Standard)
‘200 ISA’
CAN-AC2 (ISA) with Intel 82527
(Standard & Extended)
‘527 ISA’
CAN-AC2-PCI with Philips SJA 1000 ‘1000 PCI’ or ‘1000 MB
PCI’*
CAN-AC2-104 with PC104