Specifications

3 GPIB I/O Support
3-10
structure, see “Creating GPIB Message Structures” on page 3-11.
6 Click OK. The Block Parameters dialog box closes.
7 Double-click the GPIB Send/Receive block. The Block Parameters dialog
opens.
8 From the Port list, choose either COM1 or COM2. This is the port on the
target PC connected to the GPIB controller. In the
Message Struct Name
box, enter the name for the MATLAB structure this block uses to send and
receive messages to the GPIB device. In the
Sample Time box, enter the
same sample time or multiple of the sample time you entered for the step
size in the
Simulation Parameters dialog box.
Your
Block Parameter dialog box should look similar to the figure shown
below.
For more information on entering the block parameters, see “GPIB-232CT-A
Send/Receive” on page 14-13.
9 Click OK. The Block Parameters dialog box closes.