Specifications

3 GPIB I/O Support
3-8
5 Double-click the GPIB Setup block. Enter values that correspond to the DIP
switch settings you set on the GPIB-232CT-A controller. In the
Initialization Struct box, enter the name for the MATLAB structure this
block uses to send initialization messages to the GPIB device.
Note If you are not using an initialization or termination structure, enter
two single quotes.
For example, if the target PC is connected to COM1, and you set the switches
on the controller to 38400 baud, 8 databits, and 1 stopbit, your
Block
Parameter
dialog box should look similar to the figure shown below.