Specifications

11 Gespac
11-8
GESPIA-2A Digital Output
Use a separate diver block for each port. By selecting the digital output driver
block, the port is configured as output.
Scaling Input to Output
Driver Block Parameters
Number of Channels - Enter a number between 1 and 8 to select the number
of digital output lines used with this port.
Port Name. From the list, choose either PIA0A, PIA0B, PIA1A or PIA1B to
identify the port used with this block of I/O lines.
Sample Time - Enter a base sample time or a multiple of the base sample
time.
BaseAddress - Enter the base address of the board. This entry must
corresponds to the DIP-switch settings on the board. For example, if the base
address is 300 (hexadecimal), enter
0x300
Hardware Output Block Input Data Type Scaling
TTL double < 0.5 = TTL low
>
0.5 = TTL high