Specifications

GESADA-1
11-5
Enter a range code for each of the channels used. This driver allows a different
range for each D/A channel with a maximum of 2 channels.
The following table is a list of the ranges for this driver and the corresponding
range codes.
For example, if the first channel is -10 to + 10 volts and the second, third and
fourth channel are -5 to +5 volts, enter
[-10,5,5,5]
The range settings have to correspond to the jumper setting of J5 on the board.
Sample Time - Enter the base sample time or a multiple of the base sample
time.
BaseAddress - Enter the base address of the board. This entry must
correspond to the DIP-switch settings on the board. For example, if the base
address is 300 (hexadecimal), enter
0x300
The base address specifies the base address of the board and has to correspond
to the Jumper setting (J12) on the board.
Input range (V) Range code Input range (V) Range code
-10 to +10 -10 0 - 10 10
-5 to +5 -5